Muddy sediment constitutes a major fraction of the suspended sediment mass carried by the Mississippi River. Thus, adequate knowledge of the transport dynamics of suspended mud in this region is critical in devising efficient management plans for coastal Louisiana. We conducted laboratory tank experiments on the sediment suspended in the lower reaches of the Mississippi River to provide insight into the flocculation behavior of the mud. In particular, we measure how the floc size distribution responds to changing environmental factors of turbulent energy, sediment concentration, and changes in base water composition and salinity during summer and winter. We also compare observations from the tank experiments to in situ observations. Turbulence shear rate, a measure of river hydrodynamic energy, was found to be the most influential factor in determining mud floc size. All flocs produced at a given shear rate could be kept in suspension down to shear rates of approximately 20 s-1. At this shear rate, flocs on the order of 150 to 200 µm and greater can settle out. Equilibrium floc size was not found to depend on sediment concentration; flocs larger than 100 µm formed in sediment concentrations as low as 20 mgL-1. An increase in salinity generated by adding salts to river water suspensions did not increase the flocculation rate or equilibrium size. However, the addition of water collected from the Gulf of Mexico to river-water suspensions did enhance the flocculation rate and the equilibrium sizes. We speculate that the effects of Gulf of Mexico water originate from its biomatter content rather than its ion composition. Floc sizes in the mixing tanks were comparable to those from the field for similar estimated turbulent energy. Flocs were found to break within minutes under increased turbulence but can take hours to grow under conditions of reduced shear in freshwater settings. Growth was faster with the addition of Gulf of Mexico water. Overall, the experiments provide information on how suspended mud in the lower reaches of the Mississippi might respond to changes in turbulence and salinity moving from the fluvial to marine setting through natural distributary channels or man-made diversions.
In many parts of the world, ports and harbours lie adjacent to ecologically important areas of coastal habitat. In such areas port authorities, coastal managers and regulators are required to negotiate the tension between the demands of making ports ever more efficient, with wider and deeper approaches to accommodate vessels of deeper draft and larger handling areas, and the preservation of coastal habitats which are vitally important for bird and fish populations and which help protect the coast from flooding and erosion. The deepening of approach channels and berths usually results in an increased rate of sedimentation and maintenance dredging. There is an increasing recognition that such dredged sediment is a resource which should be utilised beneficially for human development activities and/or enhancement of ecological habitats. One form of beneficial use of dredged material, is termed “sediment recycling” or “strategic placement” . This form of beneficial use consists of the placement of cohesive sediment into the water column or onto the bed in such a way so that currents and waves then transport the released sediment onto the desired habitats. Sediment recycling is less widely practiced because the changes in bed level resulting from placement are generally of the order of a few centimetres/year or less and it is difficult to demonstrate whether such recycling is successful. This paper describes a methodology for the assessment of the effectiveness sediment recycling, implementing the methodology on a case study of a large-scale sediment recycling scheme in the Stour/Orwell Estuary system in the UK, designed to offset the identified adverse effects of an approach channel deepening on the estuary system. The study represents a major contribution to the consideration of non-direct beneficial use of cohesive sediment. For the first time a methodology for reliably evaluating the effects of sediment recycling, separating the effects of natural changes in morphology from the beneficial use, has been shown to be effective. This allows a robust evaluation of the effectiveness of such methods and crucially enables these methods to be tested and optimised using modelling before implementation.